DR Power 295171 Gas to Electric Conversion Kit - Manual

Dual-Action Gas to Electric Conversion Kit# 295171
DR ®
DUAL-ACTION LOG SPLITTER
Gas to Electric Conversion Kit# 295171
These instructions will aid in the Gas to Electric conversion for your Dual-Action
Log Splitter. Please keep these instructions with your Log Splitter Safety and
Operating Manual for future reference.
Tools and Supplies Needed:
 19mm Wrench

7/8" Wrench

Two 7/16" Wrenches
 Two 1/2" Wrenches
 Clean Container (for Hydraulic Fluid)
1. Relieve any pressure in the system by cycling the Operator Lever back forth a
few times.
2. Place the Clean Container under the Hydraulic Pump (Figure 1).
Note: The elbows will be left on the Pump. Only disconnect the Hoses in the
following instructions.
3. Disconnect the Pressure Hose at the Elbow with a 19mm Wrench.
4. Disconnect the intake Hose at the Elbow with a 7/8" Wrench and support the
hose end so it stays above the Tank to prevent leaking.
5. Electric Start Only: Disconnect the Terminals from the Battery (Figure 2).
Remove the Battery Clamp hardware with two 7/16" Wrenches and remove
the Battery Clamp, Battery and Battery Bracket.
6. Remove the four Bolts, Washers and Locknuts from the Engine Mount with
two 1/2" Wrenches and remove the Engine with Pump (Figure 3).
Note: The Engine was mounted using the four slotted holes on the mount, but the
Motor will use the four round holes.
Engine
Hardware
Figure 3
Figure 2
Battery Clamp
Bolts and
Locknuts Battery
Bracket
Terminals
Pressure
Hose
Connection
Figure 1
Intake Hose
Connection
Pump
Clean
Container
Before performing any maintenance procedure or inspection, stop the engine,
wait five (5) minutes to allow all parts to cool. Disconnect the spark plug
wire, keeping it away from the spark plug. Disconnect the Battery Terminals
(Electric start only).
Continued on
other side