Echo Bear Cat 70580S - Manual (Page 6)

3
S
E C T I O N
1
5. Do not allow processed material to build up in the
discharge area; this may prevent proper discharge
and can result in kickback of material through the
feed opening.
6. Do not attempt to operate the chipper with any of
the guards, deflectors, or shrouds removed. Keep
away from moving parts.
7. Keep all guards, deflectors, and shrouds in good
working condition.
8. Always stand clear of the discharge area when
operating this machine.
9. Keep your face and body back from the feed opening.
10. Do not overreach. Keep proper balance and footing
at all times.
11. Do not transport or move machine while the ma-
chine is running.
12. If the machine becomes clogged, shut off engine.
Allow machine to come to a complete stop before
clearing debris.
13. On electric start models, disconnect cables from
battery before doing any inspection or service.
14. Do not tamper with the engine governor settings on
the machine; the governor controls the maximum
safe operating speed and protects the engine and all
moving parts from damage caused by over-speed.
Additional Safety Rules for Towing
1. Always connect hitch safety chains. Make sure
trailer hitch bolts are tight and secure. Do not
attempt to tow the trailer if vehicle is not equipped
with a 2" ball.
2. Maximum towing speed should not exceed 55
M.P.H. Inflate tires to manufactures specs. as stated
on the tire sidewall. Check wheel lug bolts periodi-
cally to be sure they are tight and secure.
3. Make sure that the jack stand on trailer is in the UP
position to clear the ground during towing. Place
the jack stand on a level surface and secure it in the
DOWN position before use.
4. Shut off fuel supply to engine when towng.
5. Disconnect spark plug wire when towing.
Maintenance and Storage
1. When this equipment is stopped for servicing,
inspection, storage, or to change an accessory, make
sure that the spark plug is disconnected.
2. Store the machine out of the reach of children and
where fuel vapors will not reach an open flame or
spark. For storage periods of three months or more,
drain the fuel and dispose of it in a safe manner.
Always allow the machine to cool before storing.
Torque Chart
Standard minimum tightening
torque for normal assembly
applications.
Bolts (SAE GR5)
Size Ft. Lbs.
5/16" 20
3/8" 35
Screws
Size Ft. Lbs.
5/16" Set 15
#10-24 Set 3