Entone Hydra HD A-Series - Manual (Page 7)

COPYRIGHT     2008 ENTONE, INC. ALL RIGHTS RESERVED .
Hydra HD Quick Reference (P/N 88-4300) 7
12. Setting HDMI/Component Resolution
You can use User Menu or the Hydra front panel UP arrow to set the resolution. To use Hydra front
panel UP arrow to set resolution:
Press and hold the Hydra front panel “UP” arrow for 5 seconds.
Keep on pressing the “UP” arrow, the resolution indicator in the Hydra front panel display will
illuminate in a round robin manner from “1080i -> 720p -> 480p -> 480i”.
When your desired resolution is illuminated, release the “UP” arrow. Then, both the HDMI and
Component outputs will be set to the selected resolution.
NOTE: If your TV does not display the video or error message is displayed after you have selected a
new resolution, your TV may not support the selected resolution. Repeat the above procedures again to
find a resolution supported by your TV.
NOTE: The S-Video, RCA Composite and RF outputs are always set to 480i and will not be affected by
the HDMI and Component resolution setting.