ESI UDJ6 - Manual (Page 9)

ESI UDJ6
9
The Output section controls the playback volume of each playback signal from your audio
applications.
There are 6 individual faders for each playback channel, divided into the 1/2, 3/4 and 5/6 sections.
The M button under each channel pair allows you to mute playback for that specific channel pair. A
colored M button indicates that the mute function is enabled. When disabled, the button is gray.
The Master section allows you to control the playback volume of the main master signal.
SampleRate mode selection
Under Config > SampleRate, you can select
the playback mode and sample rate. By
default, playback with up to 6 channels and
44.1kHz is selected. You can change this to 48
kHz and you can select 96kHz playback with
maximum 2 simultaneous channels.
Please note that you must change these
settings before launching any audio
application accessing UDJ6. You cannot change these settings while any software accesses the
hardware, so you need to set up your requirements before you launch your software.
Latency setting
With the Latency menu entry under Config, you can change
the latency of the driver of UDJ6. Depending on the typical
application (e.g. for playback of software synthesizers) a
smaller latency is an advantage. At the same time, the best
latency setting indirectly depends on the performance of
your system. For most default applications, a typical
latency buffer size between 128 and 256 is standard. On a
slow system, 512 is an option.
Please note that the latency has to be setup before launching any audio application.