ESI aktiv 10s - Manual (Page 5)

ESI aktiv 10s
5
aktiv 10s
In a 5.1 or a 7.1 setup, the other surround speakers will also be connected to the source directly
although the diagram does not show that. If your source device is only stereo and / or does not have
its own base management, the satellites are connected to the outputs on the right side of the back
panel of aktiv 10s using balanced XLR cables. Refer to the following diagram:
aktiv 10s
Comments
Please make sure to not place any obstacles that may block the flow of air or that could generate
sound reflections (especially highly reflective material including glass or metal) in front of the
speaker. Also, don’t put plants in pots on top or too close to your monitoring speakers.
3. Technical Data
Please note that technical specifications are subject to change without any prior notice. The specs
and information given in this manual are up-to-date at the time of the creation of this document:
• 10" bass reflex powered subwoofer
• amplifier power: 150W@100Hz, 4 Ohm, 0.1% THD
• subwoofer crossover frequency: 50Hz - 180Hz (adjustable)
• separate satellite output crossover frequency: @100Hz and flat (adjustable)
• phase control
• volume control (to adjust input level)