ESI nEar05 eXperience - Manual (Page 6)

ESI nEar05 eXperience
Comments
6
Please also make sure to not place any obstacles that may block the flow of air or that could
generate sound reflections (especially highly reflective material including glass or metal) in front of
the speakers. Also, don’t put plants in pots on top or too close to your monitoring speakers.
4. Technical Data
specs
Specifications
- Type: 2-Way Bookshelf
- LF Driver: 5 inch Kevlar curved cone with high temperature voice coil and damped rubber surround
- HF Driver: 1 inch magnetically shield natural Silk Dome
- Frequency Response: 60Hz - 22kHz
- Crossover Frequency: 3.2kHz
- LF Amplifier Power: 40W
- HF Amplifier Power: 30W
- S/N Ratio: > 100dB below full output, 20kHz Bandwidth
- Input Connectors: 1 x XLR Balanced Input Connector
1 x TRS Balanced/ Unbalanced Input Connector
- Polarity: Positive signal at + input produce outward LF cone displacement
- Input Impedance: 20k ohms balanced,10k ohms unbalanced
- Input Sensitivity: 200 mV input produces full output with Volume control at maximum
- Protection: RF interference, output current limiting, over temperature, turn-on/off
transient, subsonic filter, external mains fuse
- Indicator: Power ON/OFF indicator on rear panel
- Power Requirements: Factory programmed for either 115V ~50/60Hz, 230V~50/60Hz or 100V~50/60Hz;
Power via detachable 3 circuit line cord
- Cabinet: vinyl laminated MDF
- Dimension: 250 mm(H) x 176 mm(W) x 200 mm(D)
- Weight: 5.0 kg/unit (without packing)
Block Diagram
Please note that technical specifications are subject to change without any prior notice. The
given in this manual are up-to-date at the time of the creation of this document.