ETA Canto - Manual (Page 24)

Floor nozzle, TURBO nozzle, brush
After any vacuuming it is recommended to check visually the brushes or collectors for
possible impurities. If there are some impurities, remove them.
Cleaning the rotary parquet C11 nozzle (Fig. 21)
If long fibres (e.g. hairs) are caught on the rotary brush, remove them so as to ensure
optimal operation of the vacuum cleaner. Using a coin or screwdriver, turn the wheel from
„ “ to „ “ and remove the rotary brush cover. Then remove the brush from the nozzle.
Do not rinse the brush with water! To attach, repeat the above-mentioned procedure in the
opposite sequence order.
Cleaning theTURBO nozzle
If hair or threads are twisted around the mounting of the drive shaft and if they cannot be
removed in the way described above, the impurities have to be removed by dismantling
the nozzles. In the lower part remove the cover. Now you can clean the nozzle using a
suitable tool (eg tweezers). Insert the lid to the nozzle in the opposite direction (you will
hear a snapping sound).
VI. TROUBLESHOOTING
Problem Cause Solution
Motor won‘t start Power supply not Check the cord, plug and the socket
connected
Switch is not on Press switch
lid cannot be closed - Dust filter inserted Check/repair fastening of the filter
safety lock activated incorrectly in the holder front in the holder
Suction output is not Regulation in MIN position. Set regulation to MAX.
sufficient
Open suction Close the hole in the hose handle
Dust filter full Replace the filter
Clogged micro-filters Clean or replace the micro-filters
Nozzle, suction hose or Remove blocking objects
tube is clogged.
The cable cannot be Twisted cable Straighten the cable
wound in the entire Take out about 50 cm of the cable
length and push button again
24
GB
/ 62