ETA Carolin - Manual (Page 14)

14
GB
– The appliance is intended for use in households only and for similar use! It is not
designed for use in hair salons or for similar commercial use!
– Do not use the appliance close to water e. g. in containers, sinks, bath tubs,
swimming pools, etc.
– Do not insert to or take out the plug from a socket with wet hands and do not pull
the power cord!
– Do not let the appliance in operation without supervision!
– Do not put the appliance on hot heat sources (e. g. oven, stove, radiator, etc.).
– The appliance must not be used without accessories and for styling wigs, hairpieces or
artificial hair.
– No part of the appliance can get in contact with places sensitive to heat (e. g. eyes, ears,
neck).
– Do not insert the accessories into any body holes.
– If the appliance is used in a bathroom, it has to be disconnected from the electric power
by unplugging the power cord from the socket because it represents a risk close to water
even if it is off.
– For additional protection we recommend installation of current protection (RCD) with the
nominal release current not exceeding 30 mA. Ask a control technician or an electrician
for advice.
– If the dryer was stored at lower temperatures, acclimatize it first, by which you remove
stiffness of the lubricating fat in bearings and mechanical resistance of the plastic parts
will be maintained.
– Holes for air ventilation must not be covered. Also, do not put the appliance on soft
surfaces (e. g. bed, towels, sheets, carpet), the hole could get covered. Penetration of
dust, hair, threads, etc. to the duct has to be prevented.
– Do not insert or throw any objects to the holes.
– Be very careful when handling the adapters during drying (they can be hot).
– When the appliance is overheated, automatic heat fuse is activated and it disconnects
power supply. If it happens, switch off the appliance and unplug it from the socket.
Remove possible visible obstacles preventing air flow and let the appliance cool down.
– Disconnect the appliance from power supply right after use by unplugging the power cord
from the socket and let it cool down before storage.
– The power cord must not be damaged with sharp or hot objects, open fire and it must not
be sunk into water.
– Do not wind the power cord around the appliance; this will extend life of the power cord.
– If you need to use the extension cord, it has to be uncorrupted and it has to comply with
the valid standards.
– Never use the appliance for any other purpose than for that described in these
instructions for use!
– The producer does not guarantee any loss caused by improper handling of the appliance
and its accessories (e. g. electrical accident, fire, burn, hair damage) and its
guarantee for the appliance does not apply in the case of non-compliance with the safety
instructions above.
II. Features of the device (pic. 1)
A – propulsion unit
A1 – temperature and air flow intensity switch
position 0 – off
position 1 – medium temperature and air flow intensity (350 W)
position 2 – medium temperature and air flow intensity (700 W)