Desa V42P-A - Manual (Page 25)

111906-01D
For more information, visit www.desatech.com For more information, visit www.desatech.com
25
25
FIREPLACE INSTALLATION
Installing Logs, Lava Rock and Glowing Embers (Cont.)
FIREPLACE INSTALLATION
Continued
WARNING: The glass door must be securely in
place before running this fireplace. Do not run this
fireplace if glass is missing or broken.
NOTICE: Do not put lava rock on burner or under
burner. Placing lava rock on burner will cause perfor-
mance problems.
6
7
Ember Material
Figure 51 - Placing Ember Material on Burner
Figure 50 - Installing Log No. 6 and Log No. 7
42" Series
Only
6. Place log #6 (left log) onto left pin of front log (#2) and the
smooth surface of rear log (#3) as shown in Figure 50. Make
sure it is seated properly.
7. For (V)V42A series only, place log #7 onto right pin of top log
(#5) as shown in Figure 50. Make sure it is seated properly
8. Place lava rock along sides and front of firebox bottom in ar-
eas that are visible only. It is not necessary to use all of the lava
rock provided.
9. Pull ember material apart into pieces no larger than a dime.
Place these pieces loosely and sparingly directly onto the ex-
posed section of the front burner and along the space between
the burner and grate prongs (see Figure 51). This will create
the glowing ember appearance as the flame touches the ember
material. Do not block air slots by using too much ember ma-
terial in one area. It is not necessary to use all of the ember
material provided.
10. Close glass door, lock door latches, replace screen, and close
louvers (see Removing/Replacing Glass Door, steps 5 through
7 on page 22).