Daewoo DWD-E1211R'S - Manual (Page 13)

13
2. WHITE PROGRAM
Note
• If you want to change the setting program during operation, press the 'Start/Pause' button to hold the
operation and change the program you want to change by pressing each corresponding button.
• Water temperature is set only to '95°C'.
• If you want to add the clothes during operation, press 'Start/Pause' button and 'Door unlock' button, then
open the Door and put the clothes into the Drum and then close Door and press 'Start/Pause' button again.
• If much SUDS is happened during operation, the washer will clean SUDS automatically.
Put the laundry into the Drum and put the detergent and softerner into the detergent
case.
Then close the Door.
• Put the detergent into the main wash room(I I marking) and prewash room(I marking)
in the detergent case.
• Softener should be below 'MAX' level.
• Put the detergent into the pre wash room(I marking) only if you want to add prewash.
• When you want to use bleach, put it into the main wash room (I I marking) with
detergent.
Press the Power button.
• The LED shows only '- --' signal.
Select the 'WHITE' program using the program selection dial.
• If you press 'Start/Pause' button aftrer pressing Power button without selecting
program, the 'NORMAL' program is selected as default program.
• 'Main wash' and '3' times rinse and '800' rpm spin speed and '95°C' water
temperature are selected automatically.
• If you want to change the 'Washing course' and 'Rinse time(s)' and 'Spin speed' ,
select program what you want to change by pressing each button.
Press the 'Start/Pause' button.
• The washer will be operated with locking Door and supplying water after sensing the
amount of laundry automatically.
1
2
3
4