Denon AVR-1909 - Manual (Page 61)


Get
ting Star
ted
Connections
Set
up
Remot
e Contr
ol
Multi-z
one
Inf
or
mation
Tr
oubleshooting
ENGLISH
Specifications
Checking the SIRIUS Signal Strength
and Radio ID
1
Either turn <SOURCE SELECT> or press [SAT TU1/2]
to select “SIRIUS”.
2 Press <STATUS> until “SIGNAL” appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display Status
EXCELLENT Signal strength is excellent
GOOD Signal strength is good
WEAK Signal strength is weak
NO SIGNAL No signal
3
Adjust the position of the antenna until “SIGNAL:
EXCELLENT” is shown on the display.
4
Press <STATUS> until the station you want to check
(example: “SR001”) is displayed.
5 Press TUNING and select channel 0 (SR000).
Channel No. and Sirius ID are alternately shown on the display.
SR000 SiriusID
************
b Write your own SIRIUS ID for storage use.
Sirius ID :
Radio ID
The strength of both the SIRIUS and terrestrial signals can be checked
at menu “Input Setup” – “Antenna Aiming” (vpage 43).
1
Either turn <SOURCE SELECT> or press [SAT TU1/2]
to select “SIRIUS”.
2
Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE
CONTROL 2] to “TUNER”.
(vpage 65 “Remote Control Unit Operations”)
3 Use TUNING to select the station.
When the station is tuned in, the name of the track and artist
are displayed.
• The channel switches continuously when TUNING is pressed and
held.
• SIRIUS Radio stations can be preset using the same procedure as
for FM/AM stations (vpage 55 “Presetting Radio Stations (Preset
Memory)” and “Listening to Preset Stations”).
b You cannot perform “Auto Preset”.
• The track name, artist name, composer name, category and reception
level can be checked by pressing <STATUS> .
• The time for which the on-screen display are displayed can be set
at menu “Manual Setup” – “Option Setup” – “On-Screen Display”
(vpage 36).
Basic Operation

Get
ting Star
ted
Connections
Set
up
Remot
e Contr
ol
Multi-z
one
Inf
or
mation
Tr
oubleshooting
ENGLISH
Presetting Radio Stations
(Preset Memory)
Your favorite broadcast stations can be preset so that you can
tune them in easily. Up to 56 stations can be preset.
1
Tune in the broadcast station you want to preset.
2 Press [MEMORY] .
3
Press SHIFT to select the block (A to G) in which the
station is to be preset.
4
Press <PRESET> or [CHANNEL +/–] to select the
preset number (1 to 8).
5 Press [MEMORY] again to complete the setting.
To preset other stations, repeat steps 1 to 5.
NOTE
Preset stations are erased by overwriting them.
1
Press SHIFT to select the memory block (A to G).
2
Press <PRESET> or [CHANNEL +/–] to select the
desired preset channel (1 to 8).
Listening to Preset Stations
Pla
ybac
k