Flowserve FC1 Flow Control - Manual (Page 2)

© 2003, Flowserve Corporation, Printed in USA
3-Position Control/Dribble Control
SR Limit Switch Method
Automax Valve Automation Systems
Installation, Operation and Maintenance Instructions
Flowserve Corporation 1350 N. Mountain Springs Parkway 1978 Foreman Dr.
Flow Control Division Springville, Utah 84663-3004 Cookeville, TN 38501
www.flowserve.com Phone: 801 489 8611 Phone: 931 432 4021
AXAIM011-00 (Auto-18) 05/03 Page 2 of 2
Performance
Maintenance
The FC1, FCDA and FCSR modules have a maximum of
only two moving parts. As such, the modules are virtually
maintenance free. Should any problems arise with the FC1,
FCDA or FCSR, consult factory.
How to Order
Order part number FC1 for single direction flow control.
Order part number FCDA for dual direction flow control for
DA actuators. Order part number FCSR for dual direction
flow control for SR actuators order appropriate NAMUR
mount bolt kit from chart at right.
Example: To order FCDA to be sandwich NAMUR
mounted with A25N solenoid valve, order
FCDA and NBK45.
Bill of Material
Item Material
Body Aluminum, Anodized
Adjustment Screws Brass
Check Ball Nitrile
Retaining Ring Spring Steel
NAMUR Accessory Bolt Chart
Other NAMUR accessories:
l. LV1:
Sandwich mount lockout and vent valve
for use with gear overrides and/or OSHA
lockout/tagout procedures.
2. APS1: Air purge system for spring retum
actuators sandwich mount with A25N
solenoid valve.
3. APS2: Air purge system for spring return
actuators Namur mount for remote/line
mount solenoid valves.
4. NPT1: 1/4" NPT adapter plate.
5. A25N: NAMUR mount solenoid valve.
6. NPTELB:1/4" NPT 90
°
adapter plate.
Note: See appropriate lOM’s for additional information on
above NAMUR accessories.
How to Specify
The single direction flow control shall be an Automax FC1
module. The dual direction flow control for double acting
actuators shall be an Automax FCDA module. The dual
direction flow control for spring return actuators shall be
an Automax FCSR module. The flow control module shall
be capable of being sandwich NAMUR mounted with other
NAMUR mount accessories.
FC1/FCDA FCSR
FC# LV1 APS1 APS2 NPT1 A25N Bolt Kit Bolt Kit
✓ ✓ NBK25 NBK40
✓ ✓ ✓ NBK50 NBK65
✓ ✓ NBK50 NBK60
✓ ✓ NBK45 NBK55
✓ ✓ ✓ NBK70 NBK80
✓ ✓ ✓ NBK55 NBK65
✓ ✓ ✓ ✓ NBK80 NBK90
✓ ✓ ✓ NBK75 NBK85
Temperature: -20
°
F to 180
°
F.
Pressure: 20 psig to 100 psig.
Media: Dry or lubricated non-corrosive gas
compatible with nitrile seals.
Estimated Cv: 0.68 inlet.
Performance: See graphs on above.