Reassembly – unit mx-85 – Flowserve MX Accutronix User Manual
Page 9
9
Accutronix MX Quick Mounting Instructions • LMENIM2312
Flow Control
Limitorque Actuation Systems
Exploded view of thrust base (MX-85 only)
Reassembly – Unit MX-85
Refer to the figure at left.
1. Clean the stem nut, washers, and bearing(s) thoroughly.
2. Slide the second set of thrust washers and bearing in place if removed.
3. Install stem nut.
4. Install first set of thrust washers and bearing.
NOTE: Order of assembly for thrust washers and bearing must be as
follows: washer, thrust bearing, washer.
Thrust baseplate installation
Mount baseplate to thrust base housing and install the six socket head cap
screws to the proper torque per the table below.
Mechanical Installation of MX
Screw Size
Torque (ft-lb)
M8 or
5
/
16
inch
12-14
M10 or
3
/
8
inch
25-30
M12 or
1
/
2
inch
40-50
M16 or
5
/
8
inch
90-100
M20 or
3
/
4
inch
180-200
Section A-A
View shown
with standard nut
Section A-A
View shown
with extended nut
A
A
10-17
10-2
10-13
10-12
10-14
10-3
10-14
10-12
10-10
10-1
10-13
10-11
10-15