Dynaudio pmn - Manual (Page 48)

46
AIR SOFT
The AIR SOFT is a software editor for the AIR System monitors. All parameters controllable via the display locally on the
System Controller, as well as the Reference Level features available via the AIR Remote can be controlled via the AIR Soft
program. As your AIR monitors most likely are placed out of your immediate reach we are therefore convinced that you will
benefit from having full control over your monitor system from your PC or Mac.
Please find additional parameter explanations on pages 15-16 in this manual.
Installation procedure PC:
• Place the Installation CD in your CD ROM drive and
open CD contents.
• Press Setup
• Follow the instructions.
Installation procedure Mac:
• Enter the Installation CD in your CD ROM drive and
open CD contents.
• Run the installer.
• Follow the instructions.
Navigating AIR SOFT
Main Screen
Network Calibrate - Main Monitors
Calibrate - AIR Base System Setup
Press to enter preset list.
Minimum requirements
• PC Pentium 2 running Windows 95/98, 2000 or
a Mac running OS 9.2 or higher (not OS X compatible)
• 64MB RAM
• 800x600 24bit screen resolution
• 1 free Serial port or USB.
Connect from Serial or USB port to any free TC
LINK connection on your AIR monitors using
ONLY the cables described on page 48.
Serial to Cat-5 cable is supplied but if an USB
port is used, an USB to Serial COM 9 port
cable must be acquired.
Air_US_rev_111.qxd 16-12-2004 14:18 Page 46