DeVillbiss Air Power Company Pressure Wave A12495 - Manual (Page 6)

6- ENG A12495
ASSEMBLY INSTRUCTIONS
3. Connect wand to gun. Tighten
securely.
2. Attach high
pressure hose
to gun. Tighten
securely.
1. Place handle assembly onto frame,
depress the snap buttons, and slide
the handle assembly onto the frame
until snap buttons snap into place.
CARTON CONTENTS
Engine Frame and
Wheel Assembly
High Pressure
Hose
Spray Gun
Quick Connect Spray Wand
Handle
Chemical
Hose
Bagged Parts
Nozzle
Cleaning
Tool
Engine
Manual
Quick
Connect
Nozzles
Nozzle
Holder
4. Place the nozzle holder onto
the panel (located on the handle
assembly) and push each nozzle
holder into place.
5. Remove five colored quick
connect nozzles from plastic
bag and insert them into correct
grommet on the nozzle holder.
NOTE: Nozzles are color coded to
match colored nozzles on panel.
The shipping plug
must be removed
and replaced with the dipstick/oil
plug before operating pressure
washer.
7. Using a 11/16"
wrench, remove
shipping plug from
pump by turning it
counterclockwise.
Discard plug.
8. Remove dipstick/oil plug from
plastic bag and install into pump,
tighten securely.
NOTE: The high pressure pump was
filled with oil at the factory. There is no
need to add oil at this time, see the
Maintenance section of this manual
for Maintenance information.
English/
Spanish
Operation
Manual
Registration
card
Engine
Oil
6. Add engine oil (supplied) to engine.
Refer to Engine Owners Manual
supplied by engine manufacturer
for correct procedure.
NOTE: There will be a slight amount of
oil in the engine from factory testing.