Formax ColorMaxLP Quick Setup Guide - Manual (Page 5)

4
Install
Missing Printhead
CONFIGURATION
3. PRINTHEAD
PRINTHEAD
2. REPLACE
Wait for printhead latch to be released.
(Select)
(Config)
Remove caps.
a
b
c Open printhead latch fully.
d
d
c
printhead
g
h
i
Check that ink is flowing through the tubes
on both sides of the printhead.
Do not discard caps!
e Remove cover from printhead
Do not discard the cover!
Slowly remove tape from electrical contacts
nozzles
No less than 45°
f
and nozzles
electrical contacts
Control Panel
will read
Online when
ready