Formax FD 8500HS - Manual

High Security Paper Shredder
FD 8500HS Cross-Cut / Level 6
OPERATOR MANUAL
FIRST EDITION
10/08
Safety Devices and Other Features
Formax 8000 Series Shredders are equipped with various safety features:
Automatic Reverse Rotation (Process takes about 6 to 8 seconds)
When too much paper is inserted, the cutter stops operating and
automatically rotates in reverse to discharge the jammed paper. An
alarm sounds. Reduce the amount of paper and restart the operation.
Door Switch
If the door is open, the shredder will not operate.
Automatic Stop
When the shredded paper fi lls the waste bin, the “FULL” light comes
on and the cutter stops operation. Open the door, remove the waste
bin and empty paper shreds. Replace the waste bin, close the door
and continue operation.
Automatic Power Shut-Off
• If the shredder operates continuously for more than 30 minutes,
the power is automatically shut off.
• If the motor is overloaded, the “STOP” LED will fl ash until it cools
down. When the fl ashing stops the shredder is ready to be used
again.
Oil Indicator
Oil regularly for peak performance. NOTE: High Security shredders require
a specialized oil that can only be ordered through Formax, part # 8000-15.The
“MANUAL” LED will fl ash after every four (4) hours of operation as an indicator to oil
the shredder cutting blades. The LED will continue to fl ash until oiled. NOTE: the
shedder will still operate when the LED is fl ashing but at a decreased load capacity.
To oil: Spread shredder oil onto the cutters through the feed opening, and allow the
oil to sit for a few minutes to permeate the cutting blades, then press the “REV” button
and hold for fi ve seconds. “MANUAL” and “REV” LED indicators on control panel will
light. The shredder will operate in reverse for one minute, then the “AUTO” LED will
light indicating the shredder is ready.
Maintenance
• Disconnect power by pulling power cord plug from wall outlet.
• To clean the exterior, wipe the surface with a soft cloth. If the surface is very dirty,
use a neutral detergent, then wipe again with a soft cloth.
CAUTION:
• Never put water directly on the surface of the shredder.
• Never clean the case with benzene or thinner, since it will cause discoloration.
• Do not dismantle the shredder. Contact your Formax Dealer for service.
NSA Approved Meets the requirements of NSA/CSS specifi cation for
Level 6 High-Security cross-cut shredders.