Foxconn P41A-G - Manual (Page 23)

16
2
16
S/PDIf oUT Connector : SPDIf_oUT
The connector is used for S/PDIF output.
Audio Connector : f_AUDIo
The audio connector supports HD Audio standard. It
provides the Front Audio output choice.
Floppy Disk Drive Connector : FLOPPY
This motherboard includes a standard floppy disk drive
(FDD) connector, supporting 360KB, 720KB, 1.2MB,
1.44MB, and 2.88MB FDDs.
front Panel Connector : fP1
This motherboard includes one connector for con-
necting the front panel switch and LED Indicators.
Hard Disk leD Connector (HDD-leD)
Connect to the chassis front panel IDE indica-
tor LED. It indicates the active status of the
hard disks. This 2-pin connector is directional
with +/- sign.
Reset Switch (ReSeT-SW)
Attach the connector to the Reset switch on the front
panel of the case; the system will restart when the
switch is pressed.
Power leD Connector (PWR-leD)
Connect to the power LED indicator on the front
panel of the chassis. The Power LED indicates the
system’s status. When the system is in operation
(S0 status), the LED is on. When the system gets
into sleep mode (S1) , the LED is blinking; When
the system is in S3/S4 sleep state or power off
mode (S5), the LED is off. This 2-pin connector is
directional with +/- sign.
Power Switch Connector (PWR-SW)
Connect to the power button on the front panel of
the chassis. Push this switch allows the system to
be turned on and off rather than using the power
supply button.
f_USb1/2
In addition to the four USB ports on the rear panel, this
product also provides two 10-pin USB header on its
motherboard. By connecting through USB cables with
them, user can quickly expand another four USB ports
on the front panel.
PORT1_L
PORT1_R
PORT2_L
SENSE_SEND
SENSE1_RETURN
PRESENCEJ
EMPTY
SENSE2_RETURN
AUD_GND
1 2
10 9
F_AUDIO
PORT2_R
SPDIF_OUT
+5V
EMPTY
SPDIF_OUT
GND
1
2
3
4
EMPTY
HDD-LED
RESET-SW
NC
+
-
PWR-SW
+
-
PWR-LED
1 2
10 9
FP1
NC
GND
VCC
D+
D-
D+
GND
D-
VCC
EMPTY
1 2
10 9
F-USB 1/2