Foxconn P9657AA-8EKRS2H User Manual
Page 43
Chapter 3 BIOS Description
36
v
Case Open Warning
This option is used to enable or disable case open warning function.
v
Wake- up by PCI card
This item is used to set the system to wake up by PCI card.
v
Power On by Ring
If this item is enabled, it allows the system to resume from a software
power down or power saving mode whenever there is an incoming call to
an installed fax. This function needs to be supported by the relevant
hardware and software.
v
Wake up On LAN
This item is used to set the system to wake up On LAN.
v
USB KB Wake-Up From S3
This item is used to set the system to wake up by USB equipment when it is
in S3 (Suspend to RAM) mode.
v
Resume by Alarm
This item is used to set the timing of the start-up function. In order to use this
function, the start-up password function must be canceled. Also, the PC power
source must not be turned off. The setting values are: Disabled and Enabled.
v
MODEM Use IRQ
This option is used to set the IRQ in which the modem can use.The system
will automatically wake up when the modem receives an incoming call. In
order for this function to work, the Fax/Modem must be connected to the W OM
header on the motherboard.
v
Suspend Mode
This option is used to set the idle time before the system enters into sleep
status.
v
HDD Power Down
This option is used to turn off hard disk power if the hard disk is idle for a given
period of time.
v
Soft-Off by PWR-BTTN
This option is used to set the power down method.This function is only valid
for systems using an ATX power supply.
PDF 文件使用 "pdfFactory" 试用版本创建