Dukane Projector 8783 - Manual (Page 59)

59
Troubleshooting
Phenomena that may be easy to be mistaken for machine defects
About the phenomenon confused with a machine defect, check and cope with it according to the following table.
Phenomenon Cases not involving a machine defect
Reference
page
Power does not
come on.
The electrical power cord is not plugged in.
Correctly connect the power cord.
0
The main power source has been interrupted during
operation such as by a power outage (blackout), etc.
Please disconnect the power plug from the power outlet,
and allow the projector to cool down at least 10 minutes,
then turn the power on again.
10, 13
Either there is no lamp and/or lamp cover, or either
of these has not been properly fixed.
Please turn the power off and disconnect the power plug from
the power outlet, and allow the projector to cool down at least
45 minutes. After the projector has sufficiently cooled down,
please make confirmation of the attachment state of the lamp
and lamp cover, and then turn the power on again.
5
Neither sounds
nor pictures are
outputted.
The signal cables are not correctly connected.
Correctly connect the connection cables.
8
Signal source does not correctly work.
Correctly set up the signal source device by referring to the
manual of the source device.
–
The input changeover settings are mismatched.
Select the input signal, and correct the settings.
14, 15
The BLANK function for pictures and the MUTE
function for sounds are working.
AV Mute may be active. Refer to the item “Sound does not
come out” and “No pictures are displayed” on the next page
to turn off the MUTE and BLANK functions.
40
Sound does not
come out.
The signal cables are not correctly connected.
Correctly connect the audio cables.
8
The MUTE function is working.
Restore the sound pressing the MUTE or VOLUME button
on the remote control.
4
The volume is adjusted to an extremely low level.
Adjust the volume to a higher level using the menu function
or the remote control.
4
The AUDIO setting is not correct.
Correctly set the AUDIO in the SETUP menu.
3
No pictures are
displayed.
The lens cover is attached.
Remove the lens cover.
3
The signal cables are not correctly connected.
Correctly connect the connection cables.
8
(continued on next page)