FSR RN-WPCS - Manual

Caution:
The RN-WPCS has no user serviceable parts.
Q
UICK
S
TART
G
UIDE
This Quick Start Guide is intended to help you
begin using the product quickly and easily. For
more detailed instructions, please consult the
User’s Manual.
Cable Connections
Current product information, downloads, and
technical support are available via the FSR
website that can be found at: www.fsrinc.com
The RN-WPCS uses a 5-pin captive screw connector.
Both the connector on the RN-WPCS and the mating plug
are labeled to identify the signals for each pin. Con-
nect the power supply, Serial Cable and IR emitter to
the RN-WPCS.
For connecting to remotely located equipment (i.e., a
projector mounted on the ceiling), use the cable
adapter. Position the cable adapter with the projector
and connect the power supply, IR emitter and Serial
cable to one side of the adapter. Make your long ca-
ble run from the RN-WPCS plug to the adapter. Be sure
to connect each signal to its corresponding signal on
each side of the adapter.
Recommended Maximum Cable Length: 50 ft
IR Learning Tips
The RN -WPCS IR receiver is located on the back of
the unit. While you can aim the IR remote di-
rectly at the receiver, this is not necessary since
To learn an IR signal, you can have the RN-WPCS
cal box.
Aim the IR remote at the upper left corner of the
unit (to the left of the Display On button).
If the wallplate is installed in an electrical box, be
sure to aim the remote into the slight gap be-
tween the PCB and the side of the electrical box
For Clean IR codes:
cent lights or sunlight
in direct view of the IR receiver
Hold the remote approximately 6-8 inches from
the RN-WPCS
Press and hold the remote button until you hear
the three “chirps” indicating complete.
Use the Help button found on the Learn IR
Command panel of the CU for more detailed IR
learning tips and information.
Command Templates
with the use of FSR provided command
templates for your devices. The FSR tem-
plate libraries will continue to grow and eventu-
ally contain a template for
out if templates are avai lable for your devices,
visit the FSR website at www.fsrinc.com. to identify
the devices you plan to control. You may also contact
FSR at [email protected] for more information.
B EFORE Y OU S TART ...
Install the CU Software
RN-WPCS
Install the RN-WPCS
onto your computer
from the product CD.
oo a ga Pro o
FSR Inc.
244 Bergen Boulevard, West Paterson, NJ 07424
Phone: 973.785.4347 · Fax: 973.785.4207
Web: www.fsrinc.com · E-mail: [email protected]
LIT1171C