FSR DV-HDA-12 - Manual (Page 7)

7
Video Connection
1. Connect your video source’s HDMI output port to the DV-HDA-12 ’s HDMI
input port using standard HDMI cables (not included). Make sure your HDMI
source and the displays are turned off before connecting the cables.
2. Connect your HDMI display’s HDMI input port to HD-102N’s HDMI output
port. Make sure your HDMI display is turned off before connecting the
cables.
3. Plug the 5V power supply into the switch’s power input port.
4. Turn on Distributor power.
5. Turn on your displays.
6. Turn on your HDMI source.
*If you do not get the correct picture or sound, Please try EDID set up:
EDID Set up (Default 1080p@2ch audio)
1. Disconnect all HDMI cable,
2. Connect Monitor or HDTV to “OUTPUT 1” back panel of DV-HDA-12
directly
3. Turn on distributor and HDTV power
4. Push the” EDID” button in front of DV-HDA-12 (3 sec) until GREEN LED
light is on.
5. Turn off the DV-HDA-12
6. Reconnect all device following the “Video Connection” instructions.
EDID [Extended Display Identification Data]
EDID is defined by a standard published by the Video Electronics Standards
Association (VESA). The EDID includes manufacturer name, product type,
phospher or filter type, timings supported by the display, display size, luminance
data and (for digital displays only) pixel mapping data.