Fulgor Milano SHC 9011 RC X - Manual (Page 8)

EN - 5
Connect the hood to the power supply using a bipolar switch with a minimum opening of 3 mm. The switch must be
easy to reach when the hood has been completely installed.
Ensure that the wiring system conforms to current standards and the earth discharge works efficiently.
Pay special attention to the hood power cable, ensure that it does not pass through any holes without a cable clamp.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person
in order to avoid a hazard.
The manufacturer declines all responsibility if the current accident prevention standards in force are not
respected, which are needed for the wiring system to operate correctly
CONTROLS
SOFT TOUCH CONTROL (Fig. 1)
There are four soft touch buttons on this version and a variable colour led (green min. speed, red max. speed).
> One button for turning the lights on and off.
> One button for turning on at 2nd speed and for turning the motor off.
N.B. If this button is kept depressed for more than three seconds, the automatic function is activated to turn the hood
off function after 10 minutes.
> Two buttons + and - for increasing and reducing the motor speed.
RADIO- CONTROL (Fig. 2)
The button ON/OFF on the hood turn on simultaneously lights and the motor at the second speed or it turns off every-
thing.
After 100 working hours of the suction motor the red led will start to flash indicating the need to wash metals filters.
To cancel the filters alarm, when the suction motor is switched off, you must press button ON/OFF long enough.
Radio control:
At the first use it is necessary to start remote control learning. With the hood turned off, keep button “+” for a long
time. The remote control learning is indicated with the flashing alarm filters led. If within one minute arrive a valid
remote control code (sent by pressing any button of the remote control ) the led will be on continuously for 3 sec-
onds and then it will turn off, indicating the proper learning.
Control buttons:
> One button for turning the lights on and off.
> One button for turning on at 2nd speed and for turning the motor off.
> Two buttons + and - for increasing and decreasing the motor speed.
> A TIMER button for turning the motor off after 10 minutes.