Fusion MS-BX3020 - Manual (Page 4)

INSTALLATION GUIDE
1. Check mounting position for adequate space (see caution)
2. Place the mounting bracket in position, then mark and drill
mounting holes.
3. Place the mounting bracket and affix with supplied screws.
4. Connect the wires from the source unit to the cabin speaker
ensuring the correct polarity is observed.
5. Attach the cabin speaker to the bracket using the washers and
mounting knobs supplied.
6. Adjust the angle of the speaker to the preferred position before
tightening the mounting knobs.
CAUTION: For speaker mounting restrictions related to Magnetic
interference, please refer to the manufacturers recommendations for any
navigational equipment.
INSTALLATION TIPS
Any speaker will only perform to its best capabilities, when correctly
placed in the listening area. FUSION Engineers recognise that unlike a
home or motor vehicle installation, there are an extremely wide range of
marine environments where speakers may be placed.
FUSION MS-BX3020 full range marine speakers are optimised and
tuned to work perfectly with the MS-AB1060R Active Subwoofer with a 2
channel speaker amplifier which not only powers the speakers but also
adds impressive low end to the audio experience, a little thought and care
with placement of the speakers will result in better sound.
• High frequencies are directional. Placing the speakers low down in the
boat will lose some of its information.
• Speakers should be placed to simulate a “sound stage”, by being
placed where you are able to hear both speakers in a stereo situation.
TROUBLESHOOTING
Before you contact your FUSION dealer or service centre, FUSION
requires that you do some simple troubleshooting to help diagnose or
resolve the problem.
PROBLEM SOLUTION
No Sound Check all connections from the source unit
amplifier to the speaker terminals are
connected correctly.
System lacks in bass Check the connections from the source
unit/amplifier to the speaker. Check Polarity.
System lacks in
high frequencies: Check Polarity
Check the bass / treble control settings on the
source unit.
Distorted sound Check all wiring
Check that it is not the surrounding panels of
the craft rattling. Check connections from the
source to the speaker.
4 5