Speaker dimension drawings, Signature series side view, Sports model front view – Fusion SG-F65W User Manual

Page 4: Classic model back view, Cleaning the speakers, Troubleshooting, There is no sound coming from the speakers, The system lacks bass or high frequencies, The audio is distorted, The led lights will not turn on

Advertising
background image

Speaker Dimension Drawings

Signature Series Side View

Dimension

6.5" Speakers

7.7" Speakers

À

76 mm (3.0 in.)

82.5 mm (3.25 in.)

Á

133 mm (5.25 in.)

153 mm (6.0 in.)

A Sports model speaker is shown, but the dimensions are the

same for the Classic model speaker.

Sports Model Front View

Dimension

6.5" Speakers

7.7" Speakers

À

176 mm (6.9375 in.)

196 mm (7.6875 in.)

Á

156 mm (6.125 in.)

176 mm (6.9375 in.)

Classic Model Back View

Dimension

6.5" Speakers

7.7" Speakers

À

200 mm (7.875 in.)

220 mm (8.6875 in.)

Á

156 mm (6.125 in.)

176 mm (6.9375 in.)

Cleaning the Speakers

NOTE: When mounted correctly, these speakers are rated IP65

for protection in the harsh marine environment from the front of

the speaker. They are not designed to withstand high pressure

water spray, which may occur when you wash down your

vessel. Failure to carefully spray-clean the vessel may damage

the product and void the warranty.

NOTICE

Do not use harsh or solvent-based cleaners on the speakers.

Using such cleaners may damage the product and void the

warranty.

1

Clean all salt water and salt residue from the speaker grill

with a damp cloth soaked in fresh water.

2

Use a mild detergent to remove a heavy buildup of salt or

stains.

Troubleshooting

Before you contact your Fusion dealer or service center, you

should perform a few simple troubleshooting steps to help

diagnose the problem.
If the Fusion speaker has been installed by a professional

installation company, you should contact the company so the

technicians can assess the problem and advise you about

possible solutions.

There is no sound coming from the speakers

• Verify that all connections from the source device and/or the

amplifier are connected correctly to the speaker terminals.

The system lacks bass or high frequencies

• Verify that the correct wire polarity is observed between the

source and speakers.
The wires should be connected positive to positive and

negative to negative.

• Verify that the speakers are attached firmly to the mounting

surface.

The audio is distorted

• Verify that the panels surrounding the speaker on the vessel

are not rattling.

• Verify that the source device and/or the amplifier are

connected to the speaker terminals correctly.

• If the speaker is connected to an amplifier, verify that the

input level of the amplifier is matched to the output level of

the stereo. For more information, see the manual for the

amplifier.

The LED lights will not turn on

• Verify that all wiring connections are correct and tight.

The LEDs pulse with the bass notes of the music

• Install a Fusion LED voltage regulator (SG-VREGLED).

Specifications

Specification

6.5" Speakers

7.7" Speakers

Tweeter type

Silk dome

Silk dome

Max. power (Watts)

230 W

280 W

RMS power (Watts)

75 W

100 W

Efficiency (1 W/1 m)

90 dB

91 dB

Frequency response (+ 3 dB)

70 Hz to 22 kHz

60 Hz to 22 kHz

Min. mounting depth (clearance) 76 mm (3 in.)

83 mm (3.27 in.)

Mounting diameter (clearance)

136 mm (5.35 in.) 156 mm (6.12 in.)

Impedance

4 ohms

4 ohms

Compass-safe distance

310 cm (122.0 in.) 360 cm (141.7 in.)

4

Advertising
This manual is related to the following products: