Gladiator GAAC30STPB Gladiator Stool - Manual

ASSEMBLY INSTRUCTIONS
Tool and Parts
TOOLS NEEDED:
PARTS SUPPLIED:
Stool Use Requirements
Intended for use in a garage.
Unpack the Stool
1. Unpack the legs, seat and parts from the box. Verify contents.
See “Parts Supplied.”
2. Remove the cardboard packing and set aside for use during
assembly. After completion of assembly, dispose of all packaging
materials properly.
NOTE: Place the cardboard packing on a level floor and use
during assembly to protect the stool from scratches.
Install Legs and Seat
1. Stand the lower leg frame upright with the center flat section
facing upward. Place the upper leg frame, with the center flat
section facing down, over the top of the lower leg frame as
shown. Using a
¹ ₄"—20 x 1" pan-head machine screw and ¹ ₄"—
20 hex nut, insert screw through upper leg section then lower leg
section. Attach nut and use fingers to tighten.
NOTE: Do not tighten the screws and nuts completely until after
leveling the leg frame.
GARAGE STOOL
Assembly Instructions
2253809A
I T ' S T I M E T O R E T H I N K T H E G A R A G E . ™
■
⁷⁄₁₆" Wrench
■ Phillips screwdriver
■ Upper leg frame
■ Lower leg frame
■ Smaller ring
■ Larger ring
■ Swivel plate
■ Seat
■
¹ ₄"—20 hex lock nut (9)
■ #14 x 1 ¹ ₂" Sheet metal
screw (4)
■
¹ ₄"—20 x 1" Pan-head
machine screw (5)
■
¹ ₄"—20 x 1¹ ₄" Pan-head
machine screw (4)
■ ¹ ₄"—20 x 1¹ ₄" Pan-head
machine screw (4)
■ ¹ ₄"—20 x 1³ ₄" Pan-head
machine screw (4)
¹ ₄"—20 x 1"
Pan-head
machine
screw (5)
¹ ₄"—20 x
1 ¹ ₄"
Pan-head
machine
screw (4)
¹ ₄"—20 x
1 ³ ₄"
Pan-head
machine
screw (4)
#14 x 1
¹ ₂
"
Sheet metal
screw (4)