Grandstream Wavestore User Manual
Page 6
Grandstream Networks, Inc.
WaveStore configuration guide
Page 6 of 16
IP cameras and IP Video Encoders/Decoders
Last Update : 04/2013
5.
In General section; Select Type to use from the list
Notes:
RTSP can be used when configuring the cameras to use H.264 or MJPEG
HTTP can only be used when configuring the camera to use MJPEG.
When using HTTP, Audio cannot be used
.
6.
In Network Capture section, enter the following :
a. Camera Type : Select Grandstream from the list (when using RTSP type)
If using HTTP, you will need to select Custom (Please refer to example 2)
b. Request : This field will change automatically to <B>/0
This will use TCP as transport protocol, if you want to use UDP, change this request to
<BU>/0 or <UB>/0
c. IP address : Enter the IP address of your Grandstream IP camera
(Example: 192.168.50.143)
d. Use custom port : This field will change automatically to 554 when using RTSP or to 80 when
using HTTP (By default, this field is unchecked)
If your Grandstream IP camera is configured to use a different port instead, you will need to check
this field and specify the port used.
e. Username : Enter Grandstream IP camera’s username (Default is admin)
- Figure 5: Device settings page -