Initial configuration of the network settings – Guntermann & Drunck DevCon-Center Installation User Manual
Page 7
Initial configuration of the network settings
G&D DevCon-Center · 4
Initial configuration of the
network settings
In order to access the web application, the network settings of the DevCon-Center
appliance on which the web application is operated are to be configured.
The following table lists the default settings of the Network A network interface:
How to configure the network settings before integrating the device into the local
network:
1. Connect the network interface of any computer to the appliance’s Network A
interface. Use a category 5 (or better) twisted pair cable for this purpose.
2. Ensure that the IP address of the computer’s network interface is part of the sub-
net to which the appliance’s IP address belongs to.
3. Switch the device on.
4. Start the computer’s web browser and enter the URL
192.168.0.1
in the address bar.
5. Authenticate your user account against the web application.
6. Click the tools sysmbal in the toolbar.
7. Click the tabs
Configuration > Interfaces
.
IP allocation:
static
IP address:
192.168.0.1
Subnet mask:
255.255.255.0
Connetion type:
Auto
NOTE:
In the default, the Network B interface is deactivated.
NOTE:
Use the IP address 192.168.0.100, for example.
NOTE:
These are the preset access data for the administrator account:
Username:
Admin
Password:
4658
Change the preset password of the administrator account. The manual of the
web application provides a detailed description of how to change the preset
access data.