Harken 20.2PT Winche - Manual (Page 10)

10 Radial Winch 20.2 PT Installation and Maintenance Manual
7. Slide off gear n°3
9. Unscrew the screw n°10 and remove
the washer n°9 ( 4Nm/35 in-lb)
8. Slide off gear n°11
Once the winch is completely disassembled, clean the parts: use a basin of diesel oil to soak metal
components and rinse plastic parts in fresh water. Once you have done this, dry the parts with
cloths that do not leave residue.
Inspect gears, bearings, pins and pawls for any signs of wear or corrosion.
Carefully check the teeth of gears and ring gears to make sure there are no traces of wear.
Check the roller bearings and check there are no breaks in the bearing cages. Replace worn or
damaged components.
Carry out maintenance on components using the products listed below.
For more information on which products to use where, refer to the exploded diagram below.
Use a brush to lightly lubricate all gears, gear pins, teeth and all moving parts with grease.
Lightly lubricate the pawls and springs with oil. Do not use grease on the pawls!