Denon DVD-2800II - Manual (Page 12)

12
ENGLISH
2 Sound output from the DVD-2800’s digital audio output connectors
Refer to
page
DVD video
DVD audio
(video part only)
Audio recording format
Dolby Digital
CP : ON
Video CD
CP : OFF
DTS
48 kHz
• Linear PCM audio is the signal recording format used for music CDs.
While the signals are recorded at 44.1 kHz/16 bit for music CDs, for DVDs they are recorded at 48 kHz/16 bit to 96 kHz/24 bit, providing
higher sound quality than music CDs.
• When “OFF” is selected, digital signals are not output from the digital audio output at this time.
(4) Connecting to a Digital Recorder (MD Recorder, DAT Deck, etc.)
L
R
Y
P B /C B
P R /C R
OPTICAL COAXIAL
VIDEO
OUT
COMPONENT
VIDEOOUT
S-VIDEO
OUT
DIGITAL OUT
(PCM/BITSTREAM) AUDIO
OUT
VIDEO IN
8 9
B
Digital audio input connector (COAXIAL)
Digital audio input connector (OPTICAL)
TV
DVD-2800
✽ Set the “AUDIO SETUP” default setting as shown below. (See
page 43.)
• “DIGITAL OUT” → “PCM”
“LPCM SELECT”
→
“ON”
Playing DVDs with incorrect settings may result noise that could
damage your ears or the speakers.
• Set the “ TV TYPE ” in “ VIDEO SETUP ” in “ SETUP ” comply with
your TV's video format. When the TV is NTSC formated, set to
NTSC. (See page 41.)
Music CD
MP3 CD
Linear PCM
96 kHz
32 ~ 48 kHz/16 bit PCM
44.1 kHz/16 bit PCM
44.1 kHz/16 bit PCM
LPCM conversion mode : OFF
LPCM conversion mode : OFF
MPEG 1
Linear PCM
MP 3
LPCM conversion mode : ON
LPCM conversion mode : ON
LPCM conversion mode : OFF
Digital out : PCM conversion
Digital out : Normal
Digital out : PCM conversion
Digital out : Normal
Settings
96 kHz PCM (when not copy-protected)
No output data (when copy-protected)
48 kHz/16 bit PCM
48 kHz/16 bit PCM
48 kHz/16 ~24 bit PCM
DTS bitstream
DTS bitstream
2 channels PCM data (48 kHz/16bit)
Dolby Digital bitstream
Digital audio data output
42
43