HuddleCamHD 3X - Manual (Page 10)

Ver 1.1 6/30/14
OSD MENU……………………………………………………………………………………………..
!!!!!(Menu does not currently work with the HuddleCam-HD™ 3x)!!!!!
The following OSD Menu information is only included in the event that
future firmware versions include full menu access. Please use the Rev
button on the remote control for flipping image for ceiling mount.
On Screen Display Menu - Use the OSD menu to access and change the
camera’s settings.
Note: You cannot manually move the camera (pan/tilt) when the OSD menu is
visible on the screen.
The Dome OSD Menu is as follows: (not applicable, see note above)
•
Pan Speed Default Value: 20
Set speed of Pan motor - Range = 1 - 63
•
Tilt Speed Default Value: 20
Set speed of Pan motor - Range = 1 – 63
•
Scan Speed (Auto Pan Mode) Default Value: 6
Set speed of boundary scan - Range = 1 – 63
•
Tour Path (uses presets) Default Value: 1
Select desired tour path - Range = 1 – 4
•
Tour Dwell Default Value: 5
Set duration to dwell on each preset - Range = 1 – 60
•
Proportion Default Value: On
Set Proportion - Range = On – Off
•
Auto Rev Default Value: P
Set camera mounting orientation – N for inverted ceiling mount
•
Frame Default Value: 60Hz
Set Refresh Rate - Range = 50Hz or 60 Hz