Hybrid Audio Technologies Mirus Series - Manual (Page 12)

Section I • Getting Started
Basic System Installation (Continued)
Once all speakers are installed, you will need to do a brief listening test with CD-quality
music that you are intimately familiar with to determine if the tweeter seems to be linear in
amplitude with the coaxials, or seems to be too muted. If the tweeter seems too muted, or
if you prefer a louder tweeter sound, simply reverse the black and red wires on the tweeter
terminals located on the frame of the coaxials. You will be changing the polarity of the
tweeter, and will be increasing the loudness of frequencies between approximately 6,000 –
10,000 Hz by doing this.
Crop your sound damping and re-install all interior panels, making sure all wiring is neatly
wire-tied away from heat and noise sources, or from abrasion and areas where the wires
may be accidentally sliced or cut, and sit back and enjoy the music.
We encourage the end-user to experiment with placement and angling of the Mirus
coaxials, and further encourage learning of timeless acoustical principals detailed in all of
our other user’s manuals, such as the Imagine User’s Manual and Car Audio Reference guide.
T
his page inTenTionally lefT blank
.
© Hybrid Audio Technologies • Cumming, GA • 770.888.8200 © Hybrid Audio Technologies • Cumming, GA • 770.888.8200 22 23