IDK MSD-54 Series Command Guide - Manual (Page 98)

MSD-54 Series Users Guide (Command Guide)
98
@GEC Get control command (Control Tally output)
Command format @GEC, no
Return value
format @GEC, no, delay, port, memo, pinno_1, out_1, pulse_1 (, pinno_2, out_2,
pulse_2, pinno_3
, out_3, pulse_3･･･)
Parameter no : Command number
1 to 32
delay : Delay time
0 to 999999
port : Tally output control
Specify 2048 for Tally output control.
memo :
Up to 14 characters of 20 to 7D except 2C (,). “2 ASCII codes”
pinno_1-6 : Pin number
22 to 24, 47 to 49
out_1-6 : Control output pin
0 = OFF, 1 = ON, 2 = TOGGLE
pulse _1-6 : Pulse width
0, 100 to 9990
Send settings of pins you want to control.
Example Send
Receive
@GEC,5
@GEC,5,20,2048,SCREEN
UP, 22,1,100
Get control command 5.
・
Control after 20 ms.
・ Memo: SCREEN UP
・ Tally output pin 22 is ON for 100
ms.
・ All other pins are not controlled
Send
Receive
@GEC,6
@GEC,6,50,2048,PROJEC
TOR ON,22,0,200,23,1,0
Get control command 6.
・
Control after 50 ms
・ Memo: PROJECTOR ON
・ Tally output pin 22 is OFF for 200
ms.
・ Tally output pin 23 is ON and the
ON state is kept.
・ All other pins are not controlled.
Related info. 8.12.1 Control commands