ILS ILS17S - Manual (Page 5)

the premier choice in Intelligent Lecterns
Intelligent Lectern Systems BV Diepmaat 16, NL-9431MP, Westerbork, The Netherlands , +31 593 568 015, [email protected]
www.intelligentlecterns.com , KvK Registrations 4084065
Modules
The ILS17S terminal is freely configurable by means of the standard modules.
More details are provided on the modules in the following sections.
The top console is placed on the height-adjustable base column.
The console can be screwed to the floor or used flexibly in connection with the base
plate module on wheels.
The console box can be locked and, when open, is held open via a gas pressure
spring.
On the right side there is an extricable glass or drinks holder.
On the table surface there is a non-slip slat of special steel. An LED strip is
integrated in this for better illumination of the lectern. Or is provided from an XLR
socket on the top and using a Littlite reading light.
The on and off switch for illumination is on the left side of the console box, directly
beneath the wooden frame of the table.
At the upper end, there are one to two anti—shock mounts from Sennheiser, such
that the use of microphones will not pick up any sound from tapping on the lectern
surface.
There are one to two 3-pin XLR cables in the console from the external connection
field bottom left to the fixture in the table sheet. Any XLR microphone with 3 pins can
be connected with this. (the second socket may be filed with a reading light.
Height adjustment
On the front side of the console there are
two illuminated press buttons of special
steel.
Press these to actuate the electrical
height adjustment. The arrow shows the
direction of electrical raising. The
minimum height of the desk top edge is
76 cm, the maximum height is 116 cm
above the ground (each without roller
module).
The raising lift and transformer are both located inside the console column, on the
right side.