InSinkErator WX-300 - Manual (Page 18)

19
PROBLEM POSSIBLE CAUSE SOLUTION
Waste Xpress stops unexpectedly. • Discharge chute misaligned.
• Fuse blown or circuit breaker
tripped at power source.
• Stop button on control center
has been pushed.
• Reinstall discharge chute to ensure
proper fi t.
• Replace fuse or reset circuit breaker.
• Push start button on control center.
Water exits Waste Xpress
at front of cabinet. • Drain line has clog.
• High water level.
• Clear drain.
• Add second waste outlet drain connect from
Waste Xpress cabinet to sewer connection
(recommended for trough applications).
Waste Xpress does not run,
but disposer and water run. • Contactor defective.
• Auger motor defective.
• Call service.
• Call service.
No water spraying onto
auger screen. • Solenoid valve clogged.
• Water turned off.
• Solenoid valve defective.
• Spray nozzles clogged.
• Timer defective.
• Timer not set properly.
• Solenoid valve installed incorrectly.
• Remove clog.
• Turn on water.
• Call service.
• Replace nozzles.
• Call service.
• Call service.
• Reinstall solenoid valve so arrow is pointing
in correct direction.
Water fl ows continuously before
controls are turned on. • Solenoid valve installed incorrectly.
• Timer is not set properly.
• Solenoid valve is defective.
• Reinstall the water solenoid valve with the
arrow on the valve pointing in the direction
of the water fl ow.
• Call service.
• Replace solenoid valve.
Overload protector trips frequently. • Disposer is overloaded with
food waste. • Do not overload disposer with excessive
amounts of food waste.
SYSTEM TROUBLESHOOTING
Troubleshooting