Jetway Computer NC81 - Manual (Page 26)

22
3-6 PC Health Status
This section shows the Status of you CPU, Fan, and Warning for overall system status. This
is only available if there is Hardware Monitor onboard.
Phoenix – AwardBIOS CMOS Setup Utility
PC Health Status
Item Help
Show PC Health In Post Enabled
Shutdown Temperature Disabled
Smart Fan Configuration Press Enter
VLDT 1.38V
VDIMM 1.97V
Vcore 1.33v
NBVCC 1.25V
CPU Temperature 38c
SYS Temperature 58c
CPU FAN Speed 255RPM
SYS FAN1 Speed 0RPM
SYS FAN2 Speed 0RPM
Menu Level >
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Optimized Defaults F7:Standard Defaults
Show PC Health in Post
During Enabled, it displays information list below. The choice is either Enabled or Disabled
CPU Smart FAN Configurations
CPU Full-Speed Temp
This item allows you setting the FAN works in full speed when the temperature over the value
which out set. If the temperature below the value but over the Idle Temperature, the FAN
will works over 60% of full speed, and the higher temperature will gain higher FAN speed,
after over the temperature which this item setting, the FAN works in full speed.
CPU Idle Temp
This item allows you setting the FAN works in 60% of full speed, when the temperature
lower than the temperature which you setting.