JLCooper eBOX GPI8 - Manual (Page 24)

24
Status Window
This window shows additional status messages of the connection
to the eBOX GPI8 you want to configure. In addition, you will
also see the firmware version of the connected eBOX GPI8.
eBOX GPI8 Programming
The parameters in this box are settings that will be downloaded
into the eBOX GPI8.
eBOX GPI8 IP address
This will be the IP address of this eBOX GPI8 when SW1, SW2
and SW3=On.
Subnet Mask
This will be the subnet mask of the eBOX GPI8.
Gateway Address
This will be the IP address of gateway router which connects to
other networks.
Port Number
This will be the TCP port of this eBOX GPI8 when SW1, SW2 and
SW3=On.
Destination IP Address
IP address of remote eBOX GPI8 when SW1, SW2 and SW3=On.
This is used when eBOX GPI8 is configured in the GPI to Ethernet
mode or the eBOX GPI8 is in client mode.
Destination Port Number
TCP port of remote eBOX GPI8 when SW1, SW2 and SW3=On.
This is used when eBOX GPI8 is configured in the GPI to Ethernet
mode or the eBOX GPI8 is in client mode.
Auto Calculate Checksum
Automatically appends a Sony type checksum to the end of each
message.
Suppress Header and Status Request
This disables Doremi message headers and VTR status requests.
Doing this allows you to use the eBOX GPI8 in applications that
do not involve a VTR.
Serial Ports Baud Rate
This parameter is not used in the eBOX GPI8.