Connecting the eclipse mx – JLCooper MX Eclipse User Manual
Page 7
Connecting the Eclipse MX
Connecting an Eclipse MX expander to a master Eclipse CX is
straightforward. Simply connect the Eclipse MX to the Eclipse
CX Expansion port using the supplied JLCooper Expansion Cable.
Additional Eclipse MX controllers can added by connecting
additional units to the last Eclipse MX as shown in the diagram
below. The order in which the Eclipse MX controllers are
connected is not important. The Eclipse MX controllers can be
connected in any order.
Connect the Eclipse MX to the Eclipse CX Expansion Port.
Connect the included power supply to the Eclipse MX.
Eclipse
CX
MX
MX
Eclipse
MX
Eclipse
MX
Note: The Expansion Slot is not used in this version of the product. Do
not install any interface card in this slot.
7