DeLonghi Pinguino Pac 1000 - Manual (Page 8)

8
in a window
pane in the
wood sill
of a win-
dow in the wall: for
optimum results,
insulate the sec-
tion of the wall
with suitable
insulating mater-
ial.
H
ø 4,18 inches
• Fit the flange supplied to the hole.
• Fit the tube to the coupling on the
back of the unit (figure A, page 6).
• Attach the end of the tube to the
flange as shown in the figure I. 18
19
19
18
S e t t i n g u p
AIR CONDITIONING WITH INSTALLATION
Pinguino can also be semi-permanently
installed (fig. G).
To install, proceed as follows:
•
Make a hole in a wall that goes through to
the outside or through the pane of a win-
dow. Respect the height and dimensions
given in figures H and I.
MAX115 cm
MIN 50 cm
When the tube is not attached, close the
hole with the stopper .
NOTE:
When the unit is installed semi-permanently,
we recommend leaving a door slightly open
(0.5 in. ‘1 cm’ is enough) to ensure an ade-
quate exchange of air.
18
19
I
The unit must only be used with the air outlet tube provided. Failure to observe the set up
and use procedures specified in this manual absolves the manufacturer from all liability.
19
46 inch.
20 inch.
30 cm
30 cm
12 inch.
12 inch.
G
5751009900 17-04-2003 15:07 Pagina 8