Denon AVR-789 - Manual (Page 57)


Get
ting Star
ted
Connections
Set
up
Remot
e Contr
ol
Multi-z
one
Inf
or
mation
Tr
oubleshooting
ENGLISH
Specifications
ENGLISH
Pla
ybac
k
1
Either turn <SOURCE SELECT> or press [SAT TU 1/2]
to select “SIRIUS”.
2
Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE
CONTROL 2] to “TUNER”.
(vpage 61 “Remote Control Unit Operations”)
3
Use TUNING to select the channel.
When the channel is tuned in, the name of the track and artist
are displayed.
Basic Operation
• The channel switches continuously when TUNING is pressed and
held.
• The song title, artist name, composer name, category and reception
level can be checked by pressing <STATUS> .
• The time (default : 30 sec) for which the on-screen display are
displayed can be set at menu “Manual Setup” – “Option Setup”
– “On-Screen Display” (vpage 32).
Press uio p to return to the original screen.
Checking the SIRIUS Signal Strength
and Radio ID
1
Either turn <SOURCE SELECT> or press [SAT TU 1/2]
to select “SIRIUS”.
2
Press <STATUS> until “SIGNAL” appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display Status
EXCELLENT Signal strength is excellent
GOOD Signal strength is good
WEAK Signal strength is weak
NO SIGNAL No signal
3 Adjust the position of the antenna until “SIGNAL:
EXCELLENT” is shown on the display.
4
Press <STATUS> until the channel you want to check
(example: “SR001”) is displayed.
5
Press TUNING and select channel 0 (SR000).
Channel No. and Sirius ID are alternately shown on the display.
SR000 SiriusID
************
b Write your own SIRIUS ID for storage use.
Sirius ID :
Radio ID
The strength of both the SIRIUS and terrestrial signals can be checked
at menu “Input Setup” – “Antenna Aiming” (vpage 39).
Presetting Radio Channels
(Preset Memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
1
Tune in the broadcast channel you want to preset.
2
Press [MEMORY] .
3
Press SHIFT to select the block (A to G) in which the
channel is to be preset.
4 Press <PRESET> or [CHANNEL +/–] to select the
preset number (1 to 8).
5
Press [MEMORY] again to complete the setting.
To preset other channels, repeat steps 1 to 5.
NOTE
Preset channels are erased by overwriting them.
1
Press SHIFT to select the memory block (A to G).
2
Press <PRESET> or [CHANNEL +/–] to select the
desired preset channel (1 to 8).
Listening to Preset Channels