Kemppi MF 29 - Manual (Page 13)

EN
3.10 Main switch I/O
When you turn the main switch of the FastMig power source into I-position, the pilot lamp
closest to this switch will light up, indicating the power source is ready for welding.
NOTE! Always start and switch off the machine with the main switch, never use the mains plug as a
switch.
3.11 Operation of cooling unit, FastCool 10
Operation of cooling unit is controlled in such a way that pump is started when welding is
started. After welding stop pump is rotating for approx. 5 min cooling the gun and the cooling
liquid to ambient temperature.
Read in operation instructions for the FastCool 10 unit the trouble situations of the liquid
circulation system and protection against torch etc. damage.
3.12 Hanging
MF 29 can be hanged to the barrier with an optional hanging frame (6185285). The machine is
not supposed to be hanged from its handle.
4. SERVICE, OPERATION DISTURBANCES
The amount of use and the working environment should be taken into consideration when
planning the frequency of maintenance of MF. Careful use and preventive maintenance will
help to ensure trouble-free operation.
The following maintenance operations should be carried out at least every six months:
Check:
• The wear of the grooves of the feed rolls. Excessive wear of grooves causes problems in
wire feed.
• The wear of the wire guide tubes of wire feed. Badly worn feed rolls and wire guide tubes
should be discarded.
• The wire guide tube in the gun should be set as near the feed rolls as possible, but not
touching them and the wire must follow a straight line from the end of the tube to the
groove of the feed roll.
• Spool brake adjustment.
• Electric connections
- Oxidised couplings must be cleaned
- Loose couplings must be tightened
Clean dust and dirt from the equipment.
NOTE! When using compressed air, always protect your eyes with proper eye protection.
In case of problems contact your KEMPPI dealer.
Lubricate the feed rolls twice a year.
11
© Kemppi Oy / 1515