Kleenmaid CH600X User Manual
Page 10
●
D
EFECTS IN APPEARANCE THAT DO NOT LEAD TO THE NON
-
FUNCTIONING OF THE HOB OR THE IMPOSSIBILITY OF USING IT ARE
NOT COVERED BY THE GUARANTEE
.
P
RECAUTIONS
: Do not arrange cleaning products or inflammable products (aerosols or recipients under
pressure) in the support furniture under the cooking hob. This also applies to paper and cookery books.
Q
Q
u
u
e
e
s
s
t
t
i
i
o
o
n
n
s
s
/
/
a
a
n
n
s
s
w
w
e
e
r
r
s
s
Q
UESTIONS
•
Lighting the burners
:
- When the knob or button is pressed, there are no sparks,
- When one knob is pressed, the ignition plugs spark on all the
burners at once,
- There are sparks but the burners do not light.
•
The retarder ( reduced flow) on the burners does not stay
alight or else is too strong.
A
NSWERS
- Check the electrical connection of the hob.
- Check that the ignition plugs are clean.
- Check that the burners are correctly assembled and clean.
- This is normal. The ignition function is centralised and controls all the bur-
ners simultaneously.
- Check that the gas supply has been turned on.
-If your gas is supplied by a bottle or a tank, check that these are not emp-
ty.
- If you have just installed the hob or changed the bottle of gas, keep the
knob pressed down and turned to the highest position for 3 to 5 seconds
until the gas reaches the burners.
Light the burner by placing the knob between maximum
and
minimum gas flow
.
Check that the injectors fitted correspond to the gas being used (see the
markings on the injectors: chapter, "Gas characteristics" at the end of part
one).
Remember: the hob comes pre-adjusted for mains gas (natural
gas).
- Check that the retarders have been adjusted correctly (see the
chapter "Changing the gas" in instruction manual).
P
P
a
a
r
r
t
t
2
2
:
:
F
F
o
o
r
r
t
t
h
h
e
e
U
U
s
s
e
e
r
r
-10-
It is easier to clean your hob before it has completely cooled. However, you should never clean your appliance whi-
le it is on. Turn all the switches to the zero position.
HOW TO PROCEED
PRODUCTS AND
ACCESSORIES TO USE
MAINTENANCE OF THE PAN
SUPPORTS AND GAS
BURNERS
•
For difficult stains use a non-abrasive paste, then
rinse with clean water. Wipe the burner caps
carefully before using your hob again. If the gas
holes on the burner get clogged or the ignition
plugs get dirty clean them with a small hard-bristled
brush (non-metallic).
•
The gas injector is the pot-shaped part in the middle
of the burner. Be careful not to obstruct it when clea-
ning, as this would interfere with the performance of
your hob.
•
A mild paste cleaner.
•
Kitchen sponge.
•
Small hard-bristled brush
HOW TO CLEAN YOUR HOB.
●