Kleenmaid CH700X User Manual
Page 14
P
P
a
a
r
r
t
t
2
2
:
:
Q
Q
u
u
e
e
s
s
t
t
i
i
o
o
n
n
s
s
/
/
a
a
n
n
s
s
w
w
e
e
r
r
s
s
-14-
Q
UESTIONS
• When installing the hob, where should the watertight seal,
supplied in the bag, be stuck?
• During installation, must the cooking hob be fixed to the
work surface with the supplied brackets?
• Lighting the burners:
- When the knob or button is pressed, there are no sparks,
- When one knob is pressed, the ignition plugs spark on all
the burners at once,
- There are sparks but the burners do not light.
• The retarder (reduced flow) on the burners does not stay
alight or else is too strong.
• Low flame (reduced flow) is hard to adjust.
• The flames are not regular.
• The knobs become very hot during cooking.
• What is used to clean the burners?
ANSWERS
- The seal should be stuck under the hob (see chapter "How to
install the hob").
- If your work surface is smooth, it is advised to fix the cooking hob
to the work surface to ensure stable operation and facilitate
cleaning. (See chapter, "How to fasten the hob").
- Check the electrical connection of the hob.
- Check that the ignition plugs are clean.
- Check that the burners are correctly assembled and clean.
- This is normal. The ignition function is centralised and controls all
the burners simultaneously.
- Check that the gas supply has been turned on.
- If your gas is supplied by a bottle or a tank, check that these are
not empty.
- If you have just installed the hob or changed the bottle of gas,
keep the knob pressed down and turned to the highest position for
3 to 5 seconds until the gas reaches the burners.
- Check that the injectors fitted correspond to the gas being used
(see the markings on the injectors chapter, "Gas characteristics" at
the end of part one).
Remember: the hob comes pre-adjusted for mains gas (natural
gas).
- Check that the retarders have been adjusted correctly (see the
chapter "Changing the gas" in instruction manual).
- Light the burner by placing the knob between maximum
and minimum gas flow
.
- The adjustment phase of the knob is situated above the
maximum flow position.
- The smallest flames are obtained when the knob is turned anti-
clockwise as far as possible.
- Check that the burners are clean, especially the slits on the
aluminium parts and the injectors located under the burners.
- Check the burners position.
- Use small saucepans on the burners near the knobs. Large sau-
cepans should be placed on the large burners farthest awa y
from the knobs.
- Centre the saucepan correctly on the burner. It should not over-
lap onto the knobs.
Use a smooth grinding cream and a cleaning sponge. For
stubborn stains, use a small, hard brush (non-metallic).