Kleenmaid MWK200 - Manual (Page 4)

4
Installation
LOCATION
BEFORE CONNECTION
• According to the model, the microwave oven must be built in.or set on a work surface at least
850 mm above floor level.
• Place the oven on a flat and horizontal surface, away from any source of heat or steam.
•Make sure that air may circulate freely around the oven.
• Allow nothing to obstruct the ventilation louvers at the back of the appliance.
• Make sure the electrical plug will be accessible after installation.
• Check whether your oven has suffered any damage during transport (deformed door or
door seal, etc.). If you see any signs of damage, contact Kleenmaid before use.
• Verify the power voltage. If there is a PERMANENT undervoltage (200-210 volts), consult your
electrical installer.
• Your installation must be protected by a 15 Amp thermal fuse.
• It is mandatory to use a power point with an earthed power point, connected in accor-
dance with current safety regulations.
• In your electrical installation, provide a device that is accessible to the installer, capable of
separating the appliance from the mains power and whose contact opening is at least 3 mm
at all of the poles.
• Never operate the oven if the supply cord and/ or its plug are damaged. In case of damage,
call in a qualified technician trained by the manufacturer.
ELECTRICAL CONNECTION