Kleenmaid VC500 - Manual (Page 4)

CAUTION - Always unplug machine at
mains outlet before dismantling any part
of machine.
Changing the paper bag:
The red bag light “d“ on the display indicates
that there is a reduced air flow. This is caused
either by a full paper bag, dirty filters, or a
blockage in the hose (12) or base (9) of the
machine. (To clear, refer to blockage section.)
The nature of the bags contents will effect the
point at which it needs changing. Fine dust may
require an earlier change even when the bag is
not filled to the top. Fluff or hair lets the air pass
through easily, so the bag may overfill.
To change the paper bag, lift the flap (5).
Then change the bag, as illustrated on its
front.
Please ensure that the bag top is located
properly on both sides of the holder (29) and
pushed in until it locks.
The used paper bag can be sealed with a cap,
which is included with each bag in the
KLEENMAID Filterbox and Service-Box (Part.-
No. 5093 ER and 5094 ER)
Changing the filters:
The KLEENMAID automatic VC 500 has two
additional filters, the microfilter and the exhaust
filter (Part.-No. 5036 ER and 5143). They are
also available together with ten paper bags in
the KLEENMAID Service-Box (Part.-No. 5094 ER).
The microfilter is located in the dust bag com-
partment. The front cover can only be closed
when the filter is fitted properly. Lift the metal
bar (31) to slide the filter in.
The exhaust filter is fitted on the base (9) below
a grill (34, filter cover), To remove the grill, push
back the catch (33).
The microfilter (30) needs to be changed when it
is dirty, or before using twenty paper bags.
We recommend changing the exhaust filter (32)
with the microfilter.
THE FILTERS MUST NOT BE WASHED.
Removing the brush roller:
To remove the brush roller (35) push the button
(36), remove the side plate (37), turn the brush
clockwise and pull the brush roller out.
To replace, slide the roller into the brush housing
and turn it until it locates into position. Push the
button (36) and press the side plate (37) back
into place.
We recommend vacuuming out the brush roller
ends periodically to prevent a build up of dust or
fibre. When cleaning hair, etc., from the brush
roller, do not cut into the bristles.
Replacing the hard floor strip:
Remove the side plate (37) and slide out the
strip. Slide new strip into the groove and refit
side plate.
Clearing blockages:
If the machine is not picking up, or the red bag
light “d“is on, but the bag is empty and the
filters are clean, then it is probably blocked.
First check the hose by placing your hand over
the end. If there is no, or very little suction, then
it is blocked. Take off the hose by squeezing the
retaining ring (4). Put it on the machine the
wrong way round. Place your hand over the free
end repeatedly with the machine on. Also check
that the tube is clear.
If the hose and tube are clear, check the swivel
neck (20) by looking down the neck where the
tube fits. Also check the trap door (38) under-
neath the machine. Ensure the passage bet-
ween the trap door and the exit to the tube is
clear.