Kleenmaid VC700 - Manual (Page 12)

11
9. Filters
When the orange bag full indicator (27) is showing, airflow is reduced. This could be because
the filter bag is full, the filters are clogged, or there may be a blockage (refer to section 12
“Removing Blockages”).
10. Changing the Filter Bag
To remove the filter bag (28), open the latch on the side of the bag housing (29). Close the
filter bag with the sealing cap (30) and lift it out. The procedure to replace the bag is
illustrated on the front of each bag. You cannot close the bag housing if the bag is fitted
incorrectly.
11. Motor Protection Filter and Exhaust Filter
The motor protection filter (31) is only accessible by removing the filter bag. Lift the motor
protection filter up by the bracket. When replacing the motor protection filter make sure that
it is pressed in position tightly. The motor protection filter should be changed when it is dirty
or at the latest, when you have used 20 filter bags.
Change the exhaust filter (11) at the same time as the motor protection filter. To do this,
carefully remove the filter retaining rings (12) and put them to the side. Next pull the
enforcement strips of the exhaust filter out of the housing slot (5) and remove the exhaust
filter from the housing.
When reassembling, please ensure the exhaust filter is fitted correctly in the housing slots and
the filter retaining rings are installed correctly.
Use only genuine Kleenmaid replacement bags and filters to ensure effectiveness
and safety. Do not wash any filters.
12
12
11
28
31
27
30 28
6
29