Kleenmaid PSA22 - Manual (Page 13)

For long vacations or absences, remove food
and unplug the refrigerator. Move the freezer
control to the O position, and clean the
interior with a baking soda solution of one
tablespoon (15 ml) of baking soda to one
quart (1 liter) of water. Leave the doors open.
Set the icemaker power switch to the
O
position and shut off the water supply
to the refrigerator.
If the temperature can drop below freezing,
have a qualified servicer drain the water
supply system (on some models) to prevent
serious property damage due to flooding.
Replacing the lightbulbs.
Turning the control to the O position does not remove power to the light circuit.
Fresh Food Compartment—Upper Light
Fresh Food Compartment—Lower Light
(on some models)
This light is located above the top drawer.
Unplug the refrigerator.
Grasp the lip at the bottom of the light
shield and pull it up and forward.
After replacing with an appliance bulb
of the same or lower wattage, replace
the shield.
Plug the refrigerator back in.
Freezer Compartment
Unplug the refrigerator.
Remove the shelf just below light shield.
(The shelf will be easier to remove if it is
emptied first.)
Lift up on the light shield to remove.
After replacing with an appliance bulb of
the same or lower wattage, reinstall the
shield by hanging it from the three tabs.
Reinstall the shelf and plug the
refrigerator back in.
13
Preparing for Vacation
Preparing to Move
Secure all loose items such as grille, shelves
and drawers by taping them securely in place
to prevent damage.
Be sure the refrigerator stays in an upright position
during moving.
Dispenser
Unplug the refrigerator.
The bulb is located on the dispenser
under the control panel. Remove the
lightbulb by turning it counterclockwise.
Replace the bulb with a bulb of the same
size and wattage.
Plug the refrigerator back in.
This bulb is located behind the controls.
Unplug the refrigerator.
To remove the light shield: Push it up
and back.
Replace the bulb with an appliance bulb
of the same or lower wattage.
To replace the light shield: Position the
plastic hooks on the light shield so they
fit into the holes on the back of the
control area.
Plug the refrigerator back in.