Water supply requirements, Water temperature water pressure, Warning – Kleenmaid LTK95 Installation Version 802116R1 User Manual

Page 17

Advertising
background image

Installation

15

802116

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Water Supply Requirements

NOTE: Water supply faucets must fit standard
3/4-14 BSP metric female couplings.
DO NOT USE SLIP-ON OR CLAMP-ON
CONNECTIONS.

NOTE: Water supply faucets should be readily
accessible to permit turning them off when washer
is not being used.

Water Temperature

Cold:

Recommended cold water temperature is 16° to
27° Celsius (60° to 80° Fahrenheit).

Hot:

Recommended hot water temperature is 49° to
60° Celsius (120° to 140° Fahrenheit).

Warm:

Mixture of hot and cold water. (Warm water
temperature is dependent upon the water temperature
and the pressure of both the hot and cold water supply
lines.)

IMPORTANT: Turn off water supply faucets after
check-out and demonstration. Owner should turn
off water supply whenever there will be an
extended period of non-use.

NOTE: A longer fill hose is available (as optional
equipment at extra cost) if the hose (supplied with
the washer) is not long enough for the installation.
Order hose as follows:

Part Number 1010102 – 2,5 m Fill Hose

Figure 17

Water Pressure

Pressure must be a minimum of 138 to a maximum of
827 kPa (20 to 120 pounds per square inch) static
pressure measured at the faucet.

NOTE: For water pressure over 827 kPa
(120 pounds per square inch) we recommend the
installation of a pressure limiting valve (Part
Number PSL50DK). This item may be purchased
by calling 1300 652 100.

NOTE: Water pressure under 138 kPa (20 pounds
per square inch) will cause an extended fill time in
the washer and may not properly flush out the
detergent dispenser.

Under certain conditions, hydrogen gas may
be produced in a hot water system that has
not been used for two weeks or more.
HYDROGEN GAS IS EXPLOSIVE. If the hot
water system has not been used for such a
period and before using the washer, turn on
all hot water faucets and let the water flow
from each for several minutes. This will
release any accumulated hydrogen gas. The
gas is flammable. Do not smoke or use an
open flame during this time.

W029

WARNING

FLW2008N

1

Water Supply Faucets

2

Cold Water Connection

3

Hot Water Connection

4

Fill Hoses

FLW2008N

1

2

3

WATER
MIXING

VALVE

4

Advertising
This manual is related to the following products: