Kleenmaid KFL850 - Manual (Page 16)

•
Push the START button (F). Sound signal
confirms the start, and the LED indicating
particular washing stages stops flashing. The
machine starts operating after a few seconds. If
the door is not properly closed after starting the
operation, the washing stage indicator LED starts
flashing again after a few seconds. When you
close the door, the machine initiates the selected
program.
•
As each washing stage is completed the relevant
washing stage indicator LED goes off and the
subsequent one goes on.
•
In case you would like to alter the washing
program after the initiated washing operation,
turn the program selector for one second to the
position “0”, followed by the selection of a new
program. Switching the machine off deletes any
previously selected additional functions (i.e. Rinse
hold), so they have to be reactivated.
Upon switching OFF, all additional pre-
selected functions are deleted; therefore
they must be switched-ON again.
If a power failure occurs during the
washing program, when the power is
restored the machine will resume the
execution of a program where it had been
interrupted.
- End of operation
Flashing LED’s for particular washing stages
indicate that the program has completed.
•
Sound signal indicates that you may now open
the door of the machine.
•
Extract the laundry from the drum and remove
any alien objects from the door gasket.
•
Leave the door ajar to allow the interior to dry.
•
Close the water inlet tap.
•
Switch the machine off by turning the program
selector to position “0”.
16 17
Start the operation