Kleenmaid LEK37A Version 510954R5 - Manual (Page 20)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
510954 18
Motor Overload Protector
The dryer’s motor overload protector stops the motor
automatically in the event of an overload. After
cooling, the overload protector will reset itself. Dryer
can be restarted by pushing the timer knob in. If
overload protector cycles again, remove the dryer from
use and call the service person to correct the problem.
Lint Filter
The lint filter is located at the front of the dryer in the
lower part of the door opening.
CLEAN THE LINT FILTER BEFORE DRYING
EACH LOAD.
Remove lint filter cover, clean lint filter and replace
cover. Annually remove lint filter and screw to vacuum
the duct under it.
IMPORTANT: The lint filter must be in place in
the door opening when using dryer or loading and
unloading dryer. If the filter is not in place, clothing
could fall into the front air duct and get into the
exhaust system, causing damage to the motor.
Figure 12
D667I
1 Lint Filter
D667I
1